Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2010G6 V6-3.5LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTIGNITION SYSTEMCAMSHAFT POSITION SENSORSERVICE AND REPAIR
2010 Pontiac G6 V6-3.5L
Camshaft Position Sensor: Service and Repair
2010 Pontiac G6 V6-3.5LSECTION Service and Repair
Camshaft Position Sensor Replacement
Removal Procedure
1. Disconnect the camshaft position (CMP) sensor electrical connector.
2. Remove the CMP sensor bolt.
3. Remove the CMP sensor.
4. Inspect the sensor O-ring for wear, cracks, or leakage if the sensor is not being replaced.
Installation Procedure
1. Lubricate the O-ring with clean engine oil and replace the O-ring if damaged.
2. Install the CMP sensor.
Caution: Refer to Fastener Caution Fastener Caution.
3. Install the CMP sensor bolt.
Tighten the bolt to 10 Nm (89 lb in).
4. Connect the CMP sensor electrical connector.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.