Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal Procedure
2009 Pontiac Vibe GT, AutomaticSECTION Removal Procedure
- Disconnect cable from battery negative terminal.
- Remove No. 1 engine cover sub-assembly.
- Remove air cleaner cap sub-assembly with hose.
- Remove air cleaner case.
- Remove ECM.
- Separate the wire harness clamp.
- Disconnect the 2 ECM connectors.
- Push the locks on the 2 levers, then raise the levers, and disconnect the 2 ECM connectors.
- Remove the 3 bolts and the ECM.
- Remove the 4 screws and 2 ECM brackets.
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
NOTE:
After disconnecting the connectors, make sure that dirt, water or other foreign matter does not contact the connecting parts of the connectors.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.