Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSPONTIAC2009VIBE GT, AUTOMATICREPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMENGINE CONTROL SYSTEM & FUEL SYSTEM - 2.4L (LAX) - INTRODUCTIONREPAIR INSTRUCTIONSCAMSHAFT POSITION SENSOR REPLACEMENTREMOVAL PROCEDURE

2009 Pontiac Vibe GT, Automatic

Removal Procedure

2009 Pontiac Vibe GT, AutomaticSECTION Removal Procedure

Remove engine cover.
Remove air cleaner cap sub-assembly with hose.

Fig 1: Exploded View Of Camshaft Position Sensor & Bolt

Courtesy of GENERAL MOTORS CORP.

Remove camshaft position sensor.
Disconnect the camshaft position sensor connector.
Remove the bolt and the camshaft position sensor.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.