SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2009VIBE BASE, 2.4 0, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 25 (OBJECT DETECTION SYSTEM)REPAIR INSTRUCTIONSVEHICLE DIRECTION ALERT ALARM WARNING MODULE REPLACEMENT
2009 Pontiac Vibe Base, 2.4 0, FWD, Standard

Vehicle Direction Alert Alarm Warning Module Replacement

2009 Pontiac Vibe Base, 2.4 0, FWD, StandardSECTION Vehicle Direction Alert Alarm Warning Module Replacement
WARNING: This page is about a different car, the 2009 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Vehicle Direction Alert Alarm Warning Module
GM1981476Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Vehicle Direction Alert Alarm Warning Module

Procedure

  1. Disconnect the electrical connector.
  2. Use a small flat bladed tool and insert along the top edge in the recessed notches and push in both tabs to release the upper edge of the module.
  3. Then slide upward to disengage the lower tabs of the module from the bracket.
  4. Refer to Control Module References for set-up and programming information.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.