SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2009VIBE BASE, 2.4 0, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 144 (DATA COMMUNICATIONS SYSTEM)REPAIR INSTRUCTIONSBODY CONTROL MODULE REPLACEMENT
2009 Pontiac Vibe Base, 2.4 0, FWD, Standard

Body Control Module Replacement

2009 Pontiac Vibe Base, 2.4 0, FWD, StandardSECTION Body Control Module Replacement
WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Body Control Module
GM1686522Courtesy of GENERAL MOTORS COMPANY
Body Control Module Replacement

Callout Component Name
Preliminary Procedure 
Remove the RH instrument panel insulator. Refer to Instrument Panel Insulator Panel Replacement - Right Side .
1 Body Control Module (BCM)
  • Depress the locking tab on the bracket and disconnect the electrical connectors to remove.
  • The replacement BCM must be programmed. Refer to Control Module References .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.