SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2009VIBE BASE, 2.4 0, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 118 (CRUISE CONTROL SYSTEM)REPAIR INSTRUCTIONSDISTANCE SENSING CRUISE CONTROL MODULE REPLACEMENT
2009 Pontiac Vibe Base, 2.4 0, FWD, Standard

Distance Sensing Cruise Control Module Replacement

2009 Pontiac Vibe Base, 2.4 0, FWD, StandardSECTION Distance Sensing Cruise Control Module Replacement
WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Distance Sensing Cruise Control Module
GM1639690Courtesy of GENERAL MOTORS COMPANY
Distance Sensing Cruise Control Module Replacement

Callout Component Name
1 Cruise Control Module Assembly
CAUTION:

Refer to Fastener Caution .

Procedure

  1. Loosen the bolts that hold the cruise control module into the T-slots on the tie bar.
  2. Disconnect the electrical connector.
  3. Slide the module out of the T-slots on the bracket.
  4. Replace the module by sliding the assembly into the T-slots on the bracket and tighten.

    Mandatory tightening sequence.

  5. Verify proper alignment of the module. Refer to Distance Sensing Cruise Control Aiming .
  6. For replacement and setup information, refer to Control Module References .

Tighten 
9 N.m (80 lb in)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.