SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2009VIBE BASE, 2.4 0, FWD, STANDARDREPAIR AND DIAGNOSISBODY & FRAMEDOOR LOCKSKEYLESS ENTRY SYSTEM AND REMOTE FUNCTIONSREPAIR INSTRUCTIONSTRANSMITTER BATTERY REPLACEMENTINSTALLATION PROCEDURE
2009 Pontiac Vibe Base, 2.4 0, FWD, Standard

Installation Procedure

2009 Pontiac Vibe Base, 2.4 0, FWD, StandardSECTION Installation Procedure
    Fig 1: Installing Transmitter Battery
    GM2045781Courtesy of GENERAL MOTORS CORP.
  1. Install a battery (lithium battery: CR2025) with the positive (+) side facing upward.
    2. Fig 2: Installing Cover
    GM2045782Courtesy of GENERAL MOTORS CORP.
  2. Install the cover.
    3. Fig 3: Installing Door Control Transmitter Module
    GM2045783Courtesy of GENERAL MOTORS CORP.
  3. Install the door control transmitter module into the transmitter housing case.
    4. Fig 4: Installing Transmitter Housing Cover
    GM2045784Courtesy of GENERAL MOTORS CORP.
  4. Install the transmitter housing cover to the transmitter housing case.
  5. Check that the transmitter LED illuminates when the switch is pressed.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.