Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2009TORRENT FWD V6-3.4LREPAIR AND DIAGNOSISENGINE, COOLING AND EXHAUSTENGINESERVICE AND REPAIROVERHAULREPAIR INSTRUCTIONS2. CRANKSHAFT BALANCER REMOVAL
2009 Pontiac Torrent FWD V6-3.4L
2. Crankshaft Balancer Removal
2009 Pontiac Torrent FWD V6-3.4LSECTION 2. Crankshaft Balancer Removal
Crankshaft Balancer Removal
Special Tools
* EN 46359 - Puller End Protector
* EN-49010 - Flywheel Holding Tool
* J 41816-A - Crankshaft Balancer Remover
For equivalent regional tools, refer to Special Tools (Special Tools).
1. Install the EN-49010 - tool to the starter mounting holes.
2. Remove the crankshaft balancer bolt and washer.
Caution: Do NOT use a power-assisted tool with the special tool in order to remove or install this component. You cannot properly control the alignment of this component using a power-assisted tool, and this can damage the component.
3. Remove the crankshaft balancer using the J 41816-A - remover along with EN 46359 - protector or equivalent.
4. Remove the EN-49010 - tool.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.