Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2009SOLSTICE L4-2.0L TURBOREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSVARIABLE VALVE TIMING SOLENOIDSERVICE AND REPAIR
2009 Pontiac Solstice L4-2.0L Turbo
Variable Valve Timing Solenoid: Service and Repair
2009 Pontiac Solstice L4-2.0L TurboSECTION Service and Repair
Camshaft Position Actuator Solenoid Valve Replacement
Removal Procedure
1. Remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement (Service and Repair).
2. Disconnect the engine wiring harness electrical connector from either the intake (2) or exhaust (1) camshaft position actuator solenoid valve, as required.
3. Remove the exhaust (1) camshaft position actuator solenoid valve bolt and valve, as required.
4. Remove the intake (2) camshaft position (CMP) actuator solenoid valve bolt and valve, as required.
5. Inspect the solenoid valve O-ring seals from damage, replace as necessary.
Installation Procedure
1. Lubricate the solenoid valve O-ring seals with clean engine oil.
Caution: Refer to Fastener Caution (Fastener Caution).
2. Install the intake (2) CMP actuator solenoid valve and bolt, as required, and tighten to 10 Nm (89 lb in).
3. Install the exhaust (1) CMP actuator solenoid valve and bolt, as required, and tighten to 10 Nm (89 lb in).
4. Connect the engine wiring harness electrical connector to the intake (1) or exhaust (2) camshaft position actuator solenoid valve, as required.
5. Install the air cleaner assembly. Refer to Air Cleaner Assembly Replacement (Service and Repair).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.