Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Drive Sprocket Support Removal
2008 Pontiac Grand Prix V6-3.8LSECTION Drive Sprocket Support Removal
Drive Sprocket Support Removal
Tools Required
* J 23907 Universal Slide Hammer and Puller
* J 26941 Drive Sprocket Support Bearing Remover
1. Inspect the drive sprocket support (522) for the following conditions:
* Damaged splines
* A damaged drive sprocket support bearing
* A damaged turbine shaft bushing (pressed inside the support)
2. Remove the drive sprocket support bearing only if the bearing is damaged.
3. Remove the drive sprocket support assembly only if the support is damaged.
4. Assemble J 23907 and J 26941 .
5. Use J 23907 and J 26941 in order to remove the bearing assembly (521) from the drive sprocket support.
6. Remove the four drive sprocket support bolts (524).
7. Remove the drive sprocket support assembly (522).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.