SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2007WAVE LT, 4D HATCHBACK, STANDARD, Y4M/MLMREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 8 (SHIFT INTERLOCK SYSTEM)COMPONENT LOCATORSHIFT LOCK CONTROL CONNECTORS (HATCHBACK)
2007 Pontiac Wave LT, 4D Hatchback, Standard, Y4M/MLM

Shift Lock Control Connectors (Hatchback)

2007 Pontiac Wave LT, 4D Hatchback, Standard, Y4M/MLMSECTION Shift Lock Control Connectors (Hatchback)
WARNING: This page is about a different variant/trim than selected.
Automatic Transmission Shift Lever (Except North America)

GM1467039Courtesy of GENERAL MOTORS CORP.
Connector Part Information
  • KET MG 610396
  • 4-Way F Series Sealed (WH)
Pin Wire Color Circuit No. Function
1 WH/BK 1075 Park Position Switch Signal
2 BK 250 Ground
3 WH/BK 1075 Park Position Switch Signal
4 BN 20 Stop Lamp Supply Voltage/Stop Lamp Switch Signal
Automatic Transmission Shift Lever (North America)

GM1467039Courtesy of GENERAL MOTORS CORP.
Connector Part Information
  • KET MG 610396
  • 4-Way F Series Sealed (WH)
Pin Wire Color Circuit No. Function
1 D-GN/WH 1076 Park Position Switch Signal
2 BK 250 Ground
3 PU 434 Automatic Transmission Shift Lock Control
4 BN 439 Ignition 1 Voltage
Automatic Transmission Shift Lever (RHD)

GM1467039Courtesy of GENERAL MOTORS CORP.
Connector Part Information
  • KET MG 610396
  • 4-Way F Series Sealed (WH)
Pin Wire Color Circuit No. Function
1 PU 434 Park Position Switch Signal
2 BK 250 Ground
3 PU 434 Park Position Switch Signal
4 L-BU 20 Stop Lamp Supply Voltage/Stop Lamp Switch Signal
Ignition Lock Module (North America)

GM1333956Courtesy of GENERAL MOTORS CORP.
Connector Part Information
  • AK 36905
  • 9-Way Relay F (BU)
Pin Wire Color Circuit No. Function
1 - - Not Used
2 YE 43 Accessory Voltage
3 - - Not Used
4 PU 434 Automatic Transmission Shift Lock Control
5 WH/BK 1075 Ignition Lock Cylinder Control Actuator Control
6 D-GN 450 Ground
7 D-GN/RD 20 Stop Lamp Switch Signal
8 D-GN/WH 1076 Park Position Switch Signal
9 - - Not Used
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.