Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2007WAVE LT, 4D HATCHBACK, STANDARD, Y4M/MLMREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 7 (MANUAL TRANSMISSION CLUTCH SYSTEM)REPAIR INSTRUCTIONSCLUTCH PILOT BEARING REPLACEMENTNOTES
2007 Pontiac Wave LT, 4D Hatchback, Standard, Y4M/MLM
Clutch Pilot Bearing Replacement: Notes
2007 Pontiac Wave LT, 4D Hatchback, Standard, Y4M/MLMSECTION Notes
WARNING: This page is about a different variant/trim than selected.
Tools Required
- J 23907 (09917-58010) Input Shaft Bearing Remover. See Special Tools .
- J 35271 (09924-17810) Flywheel Holder. See Special Tools .
- 09925-98210 Input Shaft Bearing Installer. See Special Tools .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.