Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2007WAVE LT, 4D HATCHBACK, STANDARD, Y4M/MLMREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 1 (AUTOMATIC TRANSAXLE - AISIN 81-40LE - INTRODUCTION (2 OF 2))
2007 Pontiac Wave LT, 4D Hatchback, Standard, Y4M/MLM
Section 1 (Automatic Transaxle - AISIN 81-40LE - Introduction (2 Of 2))
2007 Pontiac Wave LT, 4D Hatchback, Standard, Y4M/MLMSECTION Section 1 (Automatic Transaxle - AISIN 81-40LE - Introduction (2 Of 2))
WARNING: This page is about a different variant/trim than selected.
- Specifications
- Schematic and Routing Diagrams
- Component Locator
- Visual Identification
- Diagnostic Information and Procedures
- Repair Instructions
- Repair Instructions - On Vehicle
- Drive Plate Deflection Inspection
- Cooler Pipe Bending and Choke Inspection
- Vehicle Speed Sensor Inspection
- Input Speed Sensor Inspection
- Park/Neutral Position Switch Inspection
- Transmission Fluid Temperature Sensor Inspection
- Shift Solenoid (1, 2), Timing Solenoid, Lock-Up Solenoid Inspection
- Pressure Control Solenoid Inspection
- Range Selector Lever Cable Adjustment
- Transmission Fluid Temperature Sensor Replacement
- Park/Neutral Position Switch Adjustment
- Transmission Fluid Level Inspection
- Transmission Fluid Draining
- Gearshift Control Lever Replacement
- Shift Control Cable Replacement - Floor Shift
- Input Shaft Speed Sensor Replacement
- Output Shaft Speed Sensor Replacement
- Transmission Control Module Replacement
- Transmission Cooler Pipes and Hoses Replacement (Inlet)
- Transmission Cooler Pipes and Hoses Replacement (Outlet)
- Transmission Replacement
- Repair Instructions - Off Vehicle
- Transmission Disassemble
- Transmission Assemble
- Oil Pump Disassemble
- Oil Pump Inspection
- Oil Pump Assemble
- Direct Clutch Assembly Disassemble
- Direct Clutch Inspection
- Direct Clutch Assembly Assemble
- Planetary Ring Gear Disassemble
- Planetary Ring Gear Assemble
- One Way Clutch Disassemble
- One Way Clutch Assemble
- Forward and Reverse Clutch Disassemble
- Forward and Reverse Clutch Inspection
- Forward and Reverse Clutch Assemble
- Counter Drive Gear Disassemble
- Counter Drive Gear Assemble
- Differential Assembly Disassemble
- Differential Assembly Assemble
- Control Valve Body Disassemble
- Control Valve Body Assemble
- Repair Instructions - On Vehicle
- Description and Operation
- Special Tools and Equipment
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.