SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2007WAVE LT, 4D HATCHBACK, STANDARD, Y4M/MLMREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 32 (DISC BRAKE SYSTEM)REPAIR INSTRUCTIONSFRONT BRAKE CALIPER OVERHAULDISASSEMBLY PROCEDURE
2007 Pontiac Wave LT, 4D Hatchback, Standard, Y4M/MLM

Disassembly Procedure

2007 Pontiac Wave LT, 4D Hatchback, Standard, Y4M/MLMSECTION Disassembly Procedure
WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the caliper assembly. Refer to Brake Caliper Replacement .
    2. Fig 1: View of Caliper Guide Pin Bolts
    GM1245703Courtesy of GENERAL MOTORS CORP.
  2. Remove the caliper guide pin that connects the caliper piston housing to the retaining frame.
  3. Remove the bleeder valve protector and the bleeder valve.
    4. Fig 2: View Of Pins And Rubber Boots
    GM1245710Courtesy of GENERAL MOTORS CORP.
  4. Pull out the pins and the rubber boots.
  5. Remove the front pad brake set, including the pad springs, from the caliper. Refer to Front Disc Brake Pads Replacement .
    6. Fig 3: Removing Caliper Piston From Housing
    GM1245706Courtesy of GENERAL MOTORS CORP.
  6. Insert a cloth or a piece of hardwood into the caliper housing.
    7. CAUTION: Wear safety glasses when using compressed air in order to prevent eye injury.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.