Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSPONTIAC2007WAVE LT, 4D HATCHBACK, STANDARD, Y4M/MLMREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 17 (FIXED & MOVEABLE WINDOW SYSTEMS)REPAIR INSTRUCTIONSFRONT SIDE DOOR WINDOW REPLACEMENTINSTALLATION PROCEDURE

2007 Pontiac Wave LT, 4D Hatchback, Standard, Y4M/MLM

Installation Procedure

2007 Pontiac Wave LT, 4D Hatchback, Standard, Y4M/MLMSECTION Installation Procedure

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View of Bolts and Guide Rail

Courtesy of GENERAL MOTORS CORP.

Install the glass in the door.

NOTE: Refer to Fastener Notice .

Install the guide rail and the bolts.
Tighten: Tighten the guide rail bolts to 7 N.m (62 lb in).

Fig 2: View of Inside Lock Rods From Door Handle and Lock

Courtesy of GENERAL MOTORS CORP.

Install the glass to the window regulator with the screws.
Tighten: Tighten the door glass screws to 7 N.m (62 lb in).
Install the outside channel molding. Refer to Front Side Door Window Channel Replacement .
Install the door seal trim. Refer to Door Water Deflector Replacement .
Install the front door trim panel. Refer to Front Side Door Trim Panel Replacement (Notchback) or Front Side Door Trim Panel Replacement (Hatchback) .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.