Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2007WAVE LT, 4D HATCHBACK, STANDARD, Y4M/MLMREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 10 (SUPPLEMENTAL INFLATABLE RESTRAINT SYSTEM)REPAIR INSTRUCTIONSINFLATOR MODULE HANDLING AND SCRAPPINGAIR BAG MODULE DEPLOYMENT - INSIDE OF VEHICLE
2007 Pontiac Wave LT, 4D Hatchback, Standard, Y4M/MLM
Air Bag Module Deployment - Inside of Vehicle
2007 Pontiac Wave LT, 4D Hatchback, Standard, Y4M/MLMSECTION Air Bag Module Deployment - Inside of Vehicle
WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
When deploying an airbag inside the vehicle, make sure the vehicle doors are closed and the side windows are fully open. Wear safety glasses throughout the entire procedure. Make sure the deployment area in the vehicle is clear of people, or loose objects. Failure to follow these guidelines could result in personal injury or vehicle damage.
Deploy the air bags before disposing them. If a vehicle is to be scrapped, the air bag may be deployed inside the vehicle.
CAUTION:
When you are deploying an inflator module for disposal, perform the deployment procedures in the order listed. Failure to follow the procedures in the order listed may result in personal injury.
- Before deploying the air bags, remove all loose objects from the air bags expansion area.
- Deploy the air bags with the vehicles doors closed and the side windows open.
- Deploy the air bags only in an evacuated area. Service personnel who must be present during the deployment should be at least 10 m (33 ft) in front of the vehicle.
- Do not connect the voltage source until after having completed all other preparations for the deployment of air bags.
- Allow a deployed air bag module or pretensioner cool for 30 minutes before handling.
- Wear gloves and eye protection during the disposal procedure.
- If the deployment fails, disconnect the voltage source and wait 5 minutes before approaching the vehicle.
Deployment Procedure
CAUTION:
Refer to Sensing and Diagnostic Module Voltage after Ignition is Turned Off Caution
.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.