Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2007WAVE LT, 4D HATCHBACK, STANDARD, Y4M/MLMREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 10 (SUPPLEMENTAL INFLATABLE RESTRAINT SYSTEM)REPAIR INSTRUCTIONSINFLATABLE RESTRAINT SENSING AND DIAGNOSTIC MODULE REPLACEMENTINSTALLATION PROCEDURE
2007 Pontiac Wave LT, 4D Hatchback, Standard, Y4M/MLM
Installation Procedure
2007 Pontiac Wave LT, 4D Hatchback, Standard, Y4M/MLMSECTION Installation Procedure
WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
- Install the SDM (3).
- Remove any dirt, grease, etc. from the mounting surface.
- Position the sensor horizontally on the mounting surface.
- Point the arrow on the sensor toward the front of the vehicle.
- Tighten all of the sensor fasteners and sensor bracket fasteners to the specified torque value.
CAUTION:
Be careful when you handle a sensor. Do not strike or jolt a sensor. Before applying power to a sensor:
Failure to follow the correct procedure could cause air bag deployment, personal injury, or unnecessary SIR system repairs.
Failure to follow the correct procedure could cause air bag deployment, personal injury, or unnecessary SIR system repairs.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.