Removal Procedure

2007 Pontiac Wave LT, 4D Hatchback, Standard, Y4M/MLMSECTION Removal Procedure
    Fig 1: Removing Weatherstrip Around Windshield
    GM1248250Courtesy of GENERAL MOTORS CORP.
  1. Remove the air inlet grille. Refer to Air Inlet Grille Panel Replacement .
  2. Remove the inside rearview mirror. Refer to Rearview Mirror Replacement .
  3. Remove the weatherstrip around the windshield.
  4. Fig 2: View of Sealant Remover with J 24402-A
    GM1248252Courtesy of GENERAL MOTORS CORP.
  5. Using the glass sealant remover J 24402-AΒ  , cut the adhesive around the windshield. See Special ToolsΒ .
  6. Fig 3: Removal of Adhesive From Windshield and Windshield Frame with Knife
    GM1248253Courtesy of GENERAL MOTORS CORP.
  7. Remove the windshield from the vehicle.
  8. Using a knife, remove the adhesive from the windshield.
  9. Using a knife, remove the adhesive from the windshield frame.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.