Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSPONTIAC2007WAVE LT, 4D HATCHBACK, STANDARD, Y4M/MLMREPAIR AND DIAGNOSISBODY & FRAMEWINDOWSFIXED & MOVEABLE WINDOW SYSTEMSREPAIR INSTRUCTIONSREAR SIDE DOOR WINDOW REPLACEMENTINSTALLATION PROCEDURE

2007 Pontiac Wave LT, 4D Hatchback, Standard, Y4M/MLM

Installation Procedure

2007 Pontiac Wave LT, 4D Hatchback, Standard, Y4M/MLMSECTION Installation Procedure

Fig 1: View of Guide Rail, Bolts, and Glass

Courtesy of GENERAL MOTORS CORP.

Install the glass in the door.

NOTE: Refer to Fastener Notice .

Install the guide rail and the bolts.
Tighten: Tighten the guide rail bolts to 7 N.m (62 lb in).

Fig 2: View of Screws That Secure Glass To Window Regulator

Courtesy of GENERAL MOTORS CORP.

Position the glass within the window regulator.
Install the glass screws.
Tighten: Tighten the door glass screws to 7 N.m (62 lb in).

Fig 3: View of Exterior Rear Door Garnish Molding and Screws

Courtesy of GENERAL MOTORS CORP.

Install the door seal trim. Refer to Door Water Deflector Replacement .
Install the exterior rear door garnish molding with the screws.
Tighten: Tighten the exterior rear door garnish molding screws to 1.5 N.m (13 lb in).
Install the interior rear door garnish molding.
Install the outside channel molding. Refer to Rear Side Door Window Channel Replacement .
Install the rear door trim panel. Refer to Rear Door Trim Panel Replacement .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.