Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2007WAVE LT, 4D HATCHBACK, STANDARD, Y4M/MLMREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMENGINE CONTROLS & FUEL - 1.6L - INTRODUCTION (2 OF 2)REPAIR INSTRUCTIONSENGINE CONTROL MODULE REPLACEMENTSPARK PLUG WIRE REPLACEMENTREMOVAL PROCEDUREREMOVAL PROCEDUREINSTALLATION PROCEDURE
2007 Pontiac Wave LT, 4D Hatchback, Standard, Y4M/MLM
Removal ProcedureInstallation Procedure
2007 Pontiac Wave LT, 4D Hatchback, Standard, Y4M/MLMSECTION Removal ProcedureInstallation Procedure
- Turn OFF the ignition.
- Remove the engine cover from the engine.
- Disconnect the spark plug wire (1) at each spark plug.
- Twist each spark plug boot 1/2 turn before removing.
- Pull only on the boot or use a tool designed for this purpose in order to remove the wire from each spark plug.
- Disconnect the spark plug wire from the coil (2).
- Twist each spark plug boot 1/2 turn before removing.
- Pull only on the boot or use a tool designed for this purpose in order to remove the wires from the coil.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.