Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DBβ LIVE
HOMESERVICE MANUALSPONTIAC2007WAVE LT, 4D HATCHBACK, STANDARD, Y4M/MLMREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEDOOR LOCKSKEYLESS ENTRY SYSTEM AND REMOTE FUNCTIONSCOMPONENT LOCATORREMOTE FUNCTION CONNECTORS (HATCHBACK)
2007 Pontiac Wave LT, 4D Hatchback, Standard, Y4M/MLM
Remote Function Connectors (Hatchback)
2007 Pontiac Wave LT, 4D Hatchback, Standard, Y4M/MLMSECTION Remote Function Connectors (Hatchback)
Hood Ajar Switch Connector End View/Part Information/Terminal Identification
| Connector Part Information |
|
||
|---|---|---|---|
| Pin | Wire Color | Circuit No. | Function |
| 1 | BN/BK | 109 | Hood Ajar Switch Signal |
| 2 | OG | 1440 | Battery Positive Voltage |
Lock Cylinder Switch Connector End View/Part Information/Terminal Identification - Rear Compartment
| Connector Part Information |
|
||
|---|---|---|---|
| Pin | Wire Color | Circuit No. | Function |
| 1 | D-BU | 737 | Rear Compartment Lid Ajar Switch Signal |
| 2 | BK | 850 | Ground |
Remote Control Door Lock Receiver (RCDLR) Connector End View/Part Information/Terminal Identification
| Connector Part Information |
|
||
|---|---|---|---|
| Pin | Wire Color | Circuit No. | Function |
| 1 | D-GN/WH | 261 | Arm Alarm Signal |
| 2 | BK | 650 | Ground |
| 3 | - | - | Not Used |
| 4 | D-BU | 49 | Tamper Switch Signal (4-Door) |
| 5 | OG/BK | 737 | Rear Compartment Lid Ajar Switch Signal |
| 6 | - | - | Not Used |
| 7 | BN/BK | 109 | Hood Ajar Switch Signal |
| 8 | D-GN/WH | 157 | Courtesy Lamp Control |
| 9 | GY | 195 | Door Lock Control |
| 10 | GY/D-GN | 355 | Low Speed Cooling Fan Relay Control |
| 11 | YE/D-GN | 356 | Driver Door Lock Relay Unlock Control |
| 12 | D-BU | 49 | Tamper Switch Signal |
| 13 | D-BU | 15 | Right Turn Signal Lamps Supply Voltage |
| 14 | - | - | Not Used |
| 15 | PK | 239 | Ignition 1 Voltage |
| 16 | - | - | Not Used |
| 17 | BK/WH | 2051 | Serial Data |
| 18 | L-GN | 80 | Key In Ignition Switch Signal |
| 19 | YE | 749 | Security Indicator Control |
| 20 | D-BU | 49 | Tamper Switch Signal |
| 21-24 | - | - | Not Used |
| 25 | OG | 1340 | Battery Positive Voltage |
| 26 | L-BU | 14 | Left Turn Signal Lamps Supply Voltage |
Theft Deterrent Alarm Connector End View/Part Information/Terminal Identification
| Connector Part Information |
|
||
|---|---|---|---|
| Pin | Wire Color | Circuit No. | Function |
| 1 | D-GN/WH | 261 | Arm Alarm Signal |
| 2 | BN | 641 | Ignition 3 Voltage |
Theft Deterrent Control Module Connector End View/Part Information/Terminal Identification
| Connector Part Information |
|
||
|---|---|---|---|
| Pin | Wire Color | Circuit No. | Function |
| 1 | PK | 239 | Ignition 1 Voltage |
| 2 | OG | 240 | Battery Positive Voltage |
| 3 | - | - | Not Used |
| 4 | BK | 450 | Ground |
| 5 | D-BU/WH | 1800 | Battery Positive Voltage |
| 6 | BK/WH | 2051 | Serial Data |
| 7 | YE | 749 | Security Indicator Control |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.