Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2007WAVE BASE, 4D SEDAN, D16/MLMREPAIR AND DIAGNOSISBODY & FRAMEDOOR LOCKSTHEFT DETERRENT SYSTEMREPAIR INSTRUCTIONSPROGRAMMING THEFT DETERRENT SYSTEM COMPONENTS (TECH 2)IMMOBILIZER PROGRAMMING PROCEDURE
2007 Pontiac Wave Base, 4D Sedan, D16/MLM
Immobilizer Programming Procedure
2007 Pontiac Wave Base, 4D Sedan, D16/MLMSECTION Immobilizer Programming Procedure
- Turn the ignition switch to the ON position.
- Install the scan tool.
- Select IMMOBILIZER PROGRAMMING FUNCTION from the BODY menu.
- Follow the scan tool instructions with each key until all keys are programmed.
- Cycle the ignition 3 times as indicated by the scan tool.
- Turn the ignition to the LOCK position, disconnect the scan tool and test all the keys.
- If any key does not function, perform this procedure again with all keys.
- If any key does not accept the programming, replace it with a new key and perform this procedure again with all the keys.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.