Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal Procedure
2007 Pontiac Torrent AWDSECTION Removal Procedure
- Remove the injector sight shield. Refer to Fuel Injector Sight Shield Replacement .
- Disconnect the ignition coil/control module electrical connectors.
- Remove the spark plug wire retainer (1) from the ignition control module bracket.
- Remove the 4 bolts securing the ignition coil/control module to the ignition control module bracket.
- Position the ignition coil/control module aside out of the way.
- Remove the bolt (3) from the fuel injector wire harness bracket (4) and positive crankcase ventilation (PCV) valve fresh air tube retainer.
- Remove the engine wire harness retainers from the ignition control module bracket studs (5).
- Remove the nut (1) retaining the heater outlet pipe.
- Lift pipe up slightly to gain access for the removal of the 2 ignition control module bracket bolts.
- Remove the ignition control module bracket bolts (2).
- Remove the ignition control module bracket nuts (6).
- Remove the ignition control module bracket.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.