Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal Procedure
2007 Pontiac Torrent AWDSECTION Removal Procedure
IMPORTANT:
The throttle actuator control (TAC) module is not replaceable separate of the throttle body assembly. If the TAC module requires replacement the entire throttle body assembly must be replaced.
- Remove the air cleaner intake duct. Refer to Air Cleaner Inlet Duct Replacement .
- Remove the heater outlet pipe. Refer to Heater Outlet Pipe Replacement .
- Cover the throttle body opening with a shop towel and use the shop air to remove any dirt at the base of the throttle body.
- Disconnect the TAC module electrical connector (1) by pulling up on the connector lock (2) to release the connector from the TAC module (3).
- Remove the throttle body bolts (2).
- Remove the throttle body (1) from the intake manifold.
- Block the intake manifold opening with a clean shop towel to prevent dirt from entering.
- Remove the throttle body studs ONLY If replacement of stud is necessary.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.