Circuit/System Testing

2007 Pontiac Torrent AWDSECTION Circuit/System Testing
  1. Verify that the transmitter is the correct transmitter for the vehicle.
    • If not correct, replace the transmitter.
  2. Place the transmitter on the test pad of the J 43241  and press each button of the transmitter one at a time. The tester should sound a tone and illuminate a green light when each button is pressed.
    • If one or more buttons does not sound the tone and illuminate the green light, replace the transmitter battery and retest with the J 43241  . If the condition continues after battery replacement, replace the transmitter.
  3. Attempt to program the transmitter, refer to Transmitter Programming . The transmitter should program.
    • If the transmitter does not program, test the keyless entry antenna for an open/high resistance. If the circuit tests normal, replace the RCDLR.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.