Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2007SOLSTICE BASE, STANDARDREPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMENGINE CONTROLS & FUEL - 2.4L - DIAGNOSIS & TROUBLESHOOTINGINSPECTION/MAINTENANCE (I/M) SYSTEM DTC TABLE
2007 Pontiac Solstice Base, Standard
Inspection/Maintenance (I/M) System DTC Table
2007 Pontiac Solstice Base, StandardSECTION Inspection/Maintenance (I/M) System DTC Table
Inspection/Maintenance (I/M) System DTC Table
| System | DTCs Required to Set System Status to YES |
|---|---|
| Catalyst Monitor If an I/M System Status indicator did NOT update to YES during the Inspection/Maintenance (I/M) System Check , review each indicator and reference this table to determine each DTC associated with the I/M System Status Indicator. Each DTC listed below has specific conditions that must be met for the diagnostic to run. Included in these conditions are additional DTCs which, if set, will inhibit these DTCs from running. Reviewing and operating the vehicle within the Conditions for Running for each DTC listed below will allow the I/M System Status Indicators to transition to YES. |
|
| Catalyst | DTC P0420 |
| EVAP | DTC P0442 DTC P0443 or P0449 DTC P0446 DTC P0451, P0452, P0453, or P0454 DTC P0455 DTC P0496 |
| Oxygen Sensor | DTC P0131, P0132, P0137, or P0138 DTC P0133, P0134, P0140, P1133, P2A00 or P2A01 |
| Oxygen Sensor Heater | DTC P0030, P0036, P0053, P0054, P0135, or P0141 |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.