Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2007SOLSTICE BASE, STANDARDREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTENTERTAINMENT SYSTEMSCELLULAR SYSTEM, ENTERTAINMENT SYSTEM, AND NAVIGATION SYSTEMDIAGNOSTIC INFORMATION AND PROCEDURESGLOBAL POSITIONING SYSTEM (GPS) DATA NOT CURRENT OR INACCURATECIRCUIT/SYSTEM VERIFICATION
2007 Pontiac Solstice Base, Standard
Circuit/System Verification
2007 Pontiac Solstice Base, StandardSECTION Circuit/System Verification
IMPORTANT:
It is important to have the vehicle in an open outside area where a cellular call can be successfully placed and GPS data can be received from satellites. It is also necessary to inform the OnStar® Call Center advisor that this call is for vehicle diagnostic purposes.
- With the scan tool, observe the GPS signal status indicator for at least 10 seconds. Verify the indicator displays Yes.
- If the indicator does not display Yes, go to Component Testing.
- Call and verify the OnStar advisor receive GPS data.
- If the advisor did not receive GPS data and the call was a 'fail to voice', contact the GM Technical Assistance Center.
- If the advisor did not received GPS data and the call was not a 'fail to voice', go to Component Testing.
- Verify with the OnStar Call Center advisor that your actual position is within a reasonable distance from the actual location of the vehicle.
- If your actual position is not within a reasonable distance from the actual location of the vehicle, replace the VCIM.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.