Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006WAVE BASE, 4D SEDAN, Y4M/MLMREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROLS - 1.6L (L91) - DTC P0420 TO DTC P2076DTC P1116COMPONENT TESTING
2006 Pontiac Wave Base, 4D Sedan, Y4M/MLM
Component Testing
2006 Pontiac Wave Base, 4D Sedan, Y4M/MLMSECTION Component Testing
- Ignition OFF, disconnect the harness connector of the ECT sensor.
- Test the ECT sensor by varying the sensor temperature while monitoring the sensor resistance. Compare the readings with the TEMPERATURE VS RESISTANCE
table and verify that the resistance is within 5 percent of the specification.
- If the resistance vs. temperature is not within 5 percent, replace the ECT sensor.
IMPORTANT:
A thermometer can be used to the used to test the sensor off the vehicle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.