Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006WAVE BASE, 4D SEDAN, Y4M/MLMREPAIR AND DIAGNOSIS (SINGLE PAGE)ELECTRICALBODY ELECTRICALWIRING SYSTEMSDIAGNOSTIC INFORMATION AND PROCEDURESMICRO .64 CONNECTORSTERMINAL REMOVAL PROCEDURE
2006 Pontiac Wave Base, 4D Sedan, Y4M/MLM
Terminal Removal Procedure
2006 Pontiac Wave Base, 4D Sedan, Y4M/MLMSECTION Terminal Removal Procedure
- Locate the lever lock on the wire dress cover. While pressing the lock, pull the lever over and past the lock.
- Disconnect the connector from the component.
- Locate the 2-wire dress cover locking tabs that are opposite the wire end of the connector. Use a small flat-bladed tool to unlock the dress cover.
- Once the front 2 locks are unlocked, lift the back 2 locks that are on the wire side of the connector.
- If the connector has a nose piece, use a small flat-bladed tool to remove the nose piece by inserting the blade into the slot on the front of the connector and prying up on the nose piece.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.