Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006WAVE BASE, 4D SEDAN, Y4M/MLMREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESPROGRAMMING AND SETUP - ALL SYSTEMSREPAIR INSTRUCTIONSENGINE CONTROL MODULE PROGRAMMING AND SETUPSETUP FOR COMPONENT REPLACEMENT
2006 Pontiac Wave Base, 4D Sedan, Y4M/MLM
Setup for Component Replacement
2006 Pontiac Wave Base, 4D Sedan, Y4M/MLMSECTION Setup for Component Replacement
The replacement of some components will require a setup procedure for complete repair.
- If any of the following components are replaced, an Idle Learn Procedure must be performed. Refer to the appropriate procedure:
- Idle Learn Procedure
for the 1.6L (L91) engine
- Throttle body assembly
- ECM
- Idle Learn Procedure
for the 1.6L (L91) engine
- If any of the following components are replaced, a CKP Variation Learn Procedure must be performed. Refer to the appropriate procedure:
- CKP System Variation Learn Procedure
for the 1.6L (L91) engine
- CKP sensor
- Engine replacement
- Any engine repair that disturbs the relationship between CKP sensor and the crankshaft reluctor wheel.
- CKP System Variation Learn Procedure
for the 1.6L (L91) engine
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.