SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006WAVE BASE, 4D SEDAN, Y4M/MLMREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTANTI-THEFT SYSTEMSKEYLESS ENTRY SYSTEMREPAIR INSTRUCTIONSTRANSMITTER PROGRAMMING (TECH 2)TRANSMITTER PROGRAMMING PROCEDURE
2006 Pontiac Wave Base, 4D Sedan, Y4M/MLM

Transmitter Programming Procedure

2006 Pontiac Wave Base, 4D Sedan, Y4M/MLMSECTION Transmitter Programming Procedure
    IMPORTANT: Turn the ignition to ON before installing in the scan tool. Failure to connect in this procedure may cause communication errors and the programming procedure will not complete. Any keys that are not programmed at this time will no longer function.
  1. Turn ON the ignition with the engine OFF.
  2. Install the scan tool.
  3. Select PROGRAMMING KEY FOBS from the BODY menu.
  4. Follow the scan tool instructions with each key until all keys are programmed.
  5. Turn the ignition to the LOCK position, disconnect the TECH 2 and test all the keys.
  6. If any key does not function, refer to Keyless Entry Does Not Program .

For immobilizer programming, refer to Programming Additional Keys .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.