Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSPONTIAC2006GRAND PRIX GTREPAIR AND DIAGNOSISBODY & FRAMESEATSSEAT SYSTEMREPAIR INSTRUCTIONSSEAT BACK BOLSTER REPLACEMENT - REAR SPLIT FOLDINGINSTALLATION PROCEDURE

2006 Pontiac Grand Prix GT

Installation Procedure

2006 Pontiac Grand Prix GTSECTION Installation Procedure

Fig 1: Installing Bolster Trim Covers (Rear Split Folding)

Courtesy of GENERAL MOTORS CORP.

Install the rear seat bolster trim cover over the rear seat bolster pad.

Fig 2: J-Hook Retainers & Pad Support Frame

Courtesy of GENERAL MOTORS CORP.

Install the J-hook retainers (1) to the support frame (2).

Fig 3: Installing Bolster Trim Covers (Rear Split Folding)

Courtesy of GENERAL MOTORS CORP.

Reposition the trim cover side flap on the bolster under and over the side rail of the seat back frame.
Reposition the release handle cable to the right seat bolster, if equipped.

Fig 4: Rear Seat Bolster Bolts

Courtesy of GENERAL MOTORS CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.