Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSPONTIAC2006GRAND PRIX GTREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTCRUISE CONTROL SYSTEMSREPAIR INSTRUCTIONSCRUISE CONTROL SWITCH REPLACEMENTINSTALLATION PROCEDURE

2006 Pontiac Grand Prix GT

Installation Procedure

2006 Pontiac Grand Prix GTSECTION Installation Procedure

Fig 1: View Of Cruise Control Switch & Steering Wheel Shroud

Courtesy of GENERAL MOTORS CORP.

Install the cruise control switch (1) to the steering wheel (2).
Connect the electrical connector.

Fig 2: View Of Steering Wheel Component Screws

Courtesy of GENERAL MOTORS CORP.

Install the steering wheel shroud (3) to the steering wheel.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the steering wheel shroud screws (2).
Tighten: Tighten the steering wheel shroud screws to 3.5 N.m (31 lb in).
Install the cruise control switch screws (1).
Tighten: Tighten the cruise control switch screws to 3.5 N.m (31 lb in).
Install the steering wheel. Refer to Steering Wheel Replacement in Steering Wheel and Column.
Install the inflatable restraint steering wheel module. Refer to Inflatable Restraint Steering Wheel Module Replacement in SIR.
Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.