Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Closeout/Insulator Panel Replacement - Right
2006 Pontiac G6 V6-3.5L VIN 8SECTION Closeout/Insulator Panel Replacement - Right
CLOSEOUT/INSULATOR PANEL REPLACEMENT - RIGHT
REMOVAL PROCEDURE
1. Remove the right closeout panel.
2. Remove the wire harness clips.
INSTALLATION PROCEDURE
1. Install the wire harness clips.
2. Install the right closeout panel to the floor duct.
3. Install the right closeout panel.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.