Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Scan Tool Data Definitions
2006 Pontiac G6 V6-3.5L VIN 8SECTION Scan Tool Data Definitions
SCAN TOOL DATA DEFINITIONS
A/C Disengage History 1, 2, 3, or 4: The scan tool displays one of the following reasons why the powertrain control module (PCM) or engine control module (ECM) has disengaged the A/C compressor; None, System Voltage, Wide Open Throttle (WOT), CKP, Learn Active, Engine Run Time, Coolant Hot, Anti Stall, A/C Pressure, Engine Speed, Trans Engine Speed, A/C Pressure Sensor, Low Voltage, High Voltage, Outside Air, Temp, RPM unstable, Launch Performance, A/C Switched Off.
A/C High Side Pressure Sensor: The scan tool displays 0-3450 kPa (0-500 psi). The voltage applied to the PCM or ECM input from the A/C refrigerant pressure sensor is converted to a pressure value.
A/C High Side Pressure Sensor: The scan tool displays 0-5 volts. The voltage applied to the PCM or ECM input for the A/C refrigerant pressure sensor.
A/C Off for WOT: The scan tool displays the high throttle disable of the A/C compressor.
A/C Pressure Disable: The scan tool displays the status of the A/C high side pressure sensor. The scan tool displays Active/Inactive.
A/C Relay Command: The scan tool displays On/Off. The scan tool displays the control decision for the compressor clutch relay output as determined by the PCM or ECM.
A/C Relay Circuit History: The scan tool displays the following message stating the history status of the A/C relay control circuit. The scan tool displays OK/Open/Short.
A/C Relay Circuit Status: The scan tool displays the following message stating the circuit status of the A/C relay control circuit. The scan tool displays OK/Fault.
A/C Request Signal: The scan tool displays Yes/No. The scan tool displays Yes when the PCM or ECM receives a message to engage the A/C compressor clutch. The scan tool displays No when the PCM or ECM receives a message to disengage the A/C compressor clutch.
A/C Request Switch: The scan tool displays On/Off. The A/C request switch shows current status of the A/C request switch function on the body control module (BCM).
ECT Sensor: The scan tool displays -40 to +215°C (-40 to +419°F). The voltage applied to the PCM or ECM input from the engine coolant temperature sensor is converted to a temperature value.
Ignition 1 Signal: The scan tool shows available voltage at the PCM or ECM. The scan tool displays 0-12 volts.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.