Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISGENERAL INFORMATIONOEM GENERAL INFORMATIONCAUTIONS AND NOTICESINTRODUCTIONWORK STALL TEST CAUTION
2006 Pontiac G6 GTP, 2D Coupe, Standard
Work Stall Test Caution
2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Work Stall Test Caution
CAUTION:
One or more of the following guidelines may apply when performing specific required tests in the work stall:
- When a test requires spinning the drive wheels with the vehicle jacked up, adhere to the following precautions:
- Do not exceed 56 km/h (35 mph) when spinning one drive wheel with the other drive wheel stopped. This limit is necessary because the speedometer indicates only one-half the actual vehicle speed under these conditions. Personal injury may result from excessive wheel spinning.
- If all of the drive wheels are spinning at the same speed, do not exceed 112 km/h (70 mph). Personal injury may result from excessive wheel spinning.
- When a test requires jacking up the vehicle and running with the wheels and brake rotors removed, adhere to the following precautions:
- Do not apply the brake with the brake rotors removed.
- Do not place the drive motor in PARK with the drive wheels still spinning.
- Turn the key OFF in order to stop the wheels from spinning.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.