Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 7 (ENGINE CONTROL SYSTEM - 2.4L - INTRODUCTION (2 OF 2))REPAIR INSTRUCTIONSTHROTTLE BODY ASSEMBLY REPLACEMENTINSTALLATION PROCEDURE

2006 Pontiac G6 GTP, 2D Coupe, Standard

Installation Procedure

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Fig 1: Identifying Throttle Body

Courtesy of GENERAL MOTORS CORP.

Inspect the throttle body gasket and replace if necessary.
Position the throttle body to the intake manifold.
NOTE: Refer to Fastener Notice .
Install the throttle body bolts.
Tighten: Tighten the bolts to 10 N.m (89 lb in).

Fig 2: Locating Electronic Throttle Control (ETC) Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Connect the ETC electrical connector.
Install the air cleaner outlet. Refer to Air Cleaner Outlet Resonator Replacement .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.