Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 7 (ENGINE CONTROL SYSTEM - 2.4L - INTRODUCTION (2 OF 2))REPAIR INSTRUCTIONSAIR CLEANER ELEMENT REPLACEMENTINSTALLATION PROCEDURE

2006 Pontiac G6 GTP, 2D Coupe, Standard

Installation Procedure

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Fig 1: Identifying Air Cleaner Assembly Components

Courtesy of GENERAL MOTORS CORP.

Install the air cleaner filter into the lower air cleaner housing.
Install the upper air cleaner cover to the lower air cleaner housing.

NOTE: Refer to Fastener Notice .

Secure the air cleaner housing cover.
Tighten: Tighten the screws to 5 N.m (44 lb in).

Fig 2: Identifying MAF/IAT sensor

Courtesy of GENERAL MOTORS CORP.

Connect the MAF/IAT sensor electrical connector connector.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.