Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 17 (ENGINE CONTROL SYSTEM - 3.5L - DTC P0401 TO DTC P1133)DTC P0507CONDITIONS FOR SETTING THE DTC
2006 Pontiac G6 GTP, 2D Coupe, Standard
Conditions for Setting the DTC
2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Conditions for Setting the DTC
WARNING: This page is about a different variant/trim than selected.
- The difference between the actual idle RPM and the desired idle RPM exceeds a calibrated limit. This limit varies from 300 RPM at -40°C (-40°F) to 175 RPM at 152°C (305°F) based on engine coolant temperature.
- The above condition must be present for 8 seconds in order for the test to fail. Four tests must fail in order to set this DTC. The vehicle must exit Conditions for Running between each test.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.