Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 13 (ENGINE CONTROL SYSTEM - 3.5L - DTC P0016 TO DTC P0140)DTC P0140CONDITIONS FOR SETTING THE DTCFAST PASS TEST
2006 Pontiac G6 GTP, 2D Coupe, Standard
Fast Pass Test
2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Fast Pass Test
WARNING: This page is about a different variant/trim than selected.
During the fast pass the HO2S 2 voltage is between 381-525 mV and less than 180 samples within the first 1 minute and 30 seconds of engine run time. If the fast pass test does not report a pass then the regular test is initiated.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.