Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 12 (ENGINE CONTROL SYSTEM - 2.4L - DTC P0010 TO DTC P0341)DTC P0116DIAGNOSTIC FAULT INFORMATION
2006 Pontiac G6 GTP, 2D Coupe, Standard
Diagnostic Fault Information
2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Diagnostic Fault Information
WARNING: This page is about a different variant/trim than selected.
IMPORTANT:
Always perform the Diagnostic System Check - Vehicle
prior to using this diagnostic procedure.
DTC P0116
| Circuit | Short to Ground | High Resistance | Open | Short to Voltage | Signal Performance |
|---|---|---|---|---|---|
| ECT Sensor Signal | P0117 | P0118 | P0118 | P0118 | P0116, P0125, P0128 |
| Low Reference | - | P0118 | P0118 | P0118 | P0125, P0128 |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.