Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 10 (ENGINE CONTROL SYSTEM - 3.5L - TROUBLESHOOTING & DIAGNOSIS)SYMPTOMS - ENGINE CONTROLSVISUAL/PHYSICAL CHECK
2006 Pontiac G6 GTP, 2D Coupe, Standard
Visual/Physical Check
2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Visual/Physical Check
WARNING: This page is about a different variant/trim than selected.
NOTE:
Use the connector test adapter kit J 35616-A for any test that requires probing the following items:
Using this kit will prevent damage caused by the improper probing of connector terminals.
- The PCM harness connectors
- The electrical center fuse/relay cavities
- The component terminals
- The component harness connector
Using this kit will prevent damage caused by the improper probing of connector terminals.
Several of the symptom procedures call for a careful visual and physical inspection. This can lead to correcting a condition without further tests and can save time. This inspection should include the following areas:
- Ensure that the control module grounds are clean, tight, and correctly located. Refer to Master Electrical Component List and Power and Grounding Connector End Views .
- Inspect vacuum hoses for splits, kinks, and proper connections, as shown on the Vehicle Emission Control Information label. Inspect thoroughly for any type of a leak or a restriction. Refer to Emission Hose Routing Diagram and Evaporative Emissions (EVAP) Hose Routing Diagram .
- Inspect for a dirty or restricted air filter.
- Inspect for water intrusion in the mass air flow/intake air temperature (MAF/IAT) sensor connector, heated oxygen sensor (HO2S) connectors, control module connectors or any other harness connectors.
- Inspect the air intake ducts, particularly between the MAF sensor and the throttle body for the following conditions:
- Collapsed
- Damaged areas
- Looseness
- Incorrect installation
- Leaking
- Inspect for air leaks at the throttle body mounting area, the mass air flow (MAF) sensor and intake manifold sealing surfaces.
- Inspect the wiring harness for the following conditions:
- Poor connections
- Pinches
- Cuts
- Inspect for loose, damaged, unseated, or missing sensors/components.
- Inspect terminals for corrosion and correct contact.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.