SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 1 (ENGINE CONTROL SYSTEM - 3.5L - INTRODUCTION (2 OF 2))REPAIR INSTRUCTIONSTHROTTLE BODY ASSEMBLY REPLACEMENTINSTALLATION PROCEDURE
2006 Pontiac G6 GTP, 2D Coupe, Standard

Installation Procedure

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Installation Procedure
WARNING: This page is about a different variant/trim than selected.
    Fig 1: Removing/Installing Throttle Body
    GM1239002Courtesy of GENERAL MOTORS CORP.
  1. Install a new gasket, if necessary.
  2. Install the throttle body assembly.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the throttle body nuts and the bolts.

    Tighten:  Tighten the nuts and the bolts to 10 N.m (89 lb in).

    4. Fig 2: Identifying Heater Pipe Nut At Throttle Body
    GM1239021Courtesy of GENERAL MOTORS CORP.
  4. Install the heater pipe nut to the throttle body.

    Tighten:  Tighten the nut to 25 N.m (18 lb ft).

  5. Connect the ETC electrical connector.
  6. Install the air cleaner intake duct. Refer to Air Cleaner Intake Duct Replacement .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.