Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 1 (ENGINE CONTROL SYSTEM - 3.5L - INTRODUCTION (2 OF 2))COMPONENT LOCATORENGINE CONTROLS CONNECTOR END VIEWSKNOCK SENSOR (KS) 2
2006 Pontiac G6 GTP, 2D Coupe, Standard
Knock Sensor (KS) 2
2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Knock Sensor (KS) 2
WARNING: This page is about a different variant/trim than selected.
Engine Controls Connector End Views
Connector Part Information
Terminal Part Information
|
Knock Sensor (KS) 2
| Pin | Wire Color | Circuit No. | Function |
|---|---|---|---|
| A | L-BU | 1876 | Knock Sensor 2 Signal |
| B | GY | 2303 | Low Reference |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.