SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 991 (WIPER SYSTEM & WASHER SYSTEM)REPAIR INSTRUCTIONSWIPER MOTOR MODULE REPLACEMENTREMOVAL PROCEDURE
2006 Pontiac G6 GTP, 2D Coupe, Standard

Removal Procedure

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Removal Procedure
WARNING: This page is about a different car, the 2007 Pontiac Montana SV6, 2007 Chevrolet Uplander, and 2007 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open and support the hood.
    2. Fig 1: Removing/Installing Wiper Arm
    GM1480118Courtesy of GENERAL MOTORS CORP.
  2. Remove the driver side wiper arm (2). Refer to Wiper Arm Replacement .
    3. Fig 2: Removing/Installing Passenger Side Wiper Arm
    GM1480119Courtesy of GENERAL MOTORS CORP.
  3. Remove the passenger side wiper arm (3). Refer to Wiper Arm Replacement .
  4. Remove the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement (Buick)  or Air Inlet Grille Panel Replacement (Chevrolet)  or Air Inlet Grille Panel Replacement (Pontiac) .
  5. Lower the washer container into the engine compartment. Refer to Washer Solvent Container Replacement .
    6. Fig 3: Disconnecting/Reconnecting Wiper Motor Connector
    GM1501847Courtesy of GENERAL MOTORS CORP.
  6. Disconnect the electrical connector (2) from the wiper motor (1).
    7. Fig 4: Removing/Installing Wiper Motor Module
    GM1480117Courtesy of GENERAL MOTORS CORP.
  7. Remove the 4 bolts, as shown, from the wiper module (5).
    8. Fig 5: Positioning Wiper Module Assembly
    GM1527641Courtesy of GENERAL MOTORS CORP.
  8. Carefully guide the passenger side module out first from the opening in the front plenum.
  9. Pull the module from the drive side fender flange opening.
  10. Remove the module from the vehicle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.