Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 989 (MIRROR SYSTEM)REPAIR INSTRUCTIONSMIRROR FACE REPLACEMENT

2006 Pontiac G6 GTP, 2D Coupe, Standard

Mirror Face Replacement

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Mirror Face Replacement

WARNING: This page is about a different car, the 2007 Pontiac Montana SV6, 2007 Chevrolet Uplander, and 2007 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Mirror Face

Courtesy of GENERAL MOTORS CORP.

Mirror Face Replacement

Callout

Component Name

Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .

Mirror Glass, Outside Rearview

CAUTION: Refer to Glass and Sheet Metal Handling Caution .

Tip:

Apply masking tape to the top of the outside of the mirror housing to prevent damage.
Push the mirror face inward at the bottom until full travel is reached.
Insert a J 38778 Door Trim Pad Clip Remover or equivalent behind the glass and the first rib support and pry outward until the mirror face is released.
When installing the mirror glass, align the mirror face to the backing plate and apply pressure, using a rubber sanding block or equivalent, until an audible click is heard.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.