Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 982 (ANTILOCK BRAKE SYSTEM, TRACTION CONTROL SYSTEM & STABILITY CONTROL SYSTEM)REPAIR INSTRUCTIONSBRAKE PRESSURE MODULATOR VALVE REPLACEMENTINSTALLATION PROCEDURE

2006 Pontiac G6 GTP, 2D Coupe, Standard

Installation Procedure

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Installation Procedure

WARNING: This page is about a different car, the 2007 Pontiac Montana SV6, 2007 Chevrolet Uplander, and 2007 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.

Install EBCM onto the BPMV if replacing the BPMV only. Refer to Electronic Brake Control Module Replacement .

Fig 1: Removing/Installing BPMV To Mounting Bracket Bolts

Courtesy of GENERAL MOTORS CORP.

Install BPMV and EBCM as an assembly onto the mounting bracket studs.

NOTE: Refer to Fastener Notice .

Install the bolt that connects the BPMV assembly to the mounting bracket.
Tighten: Tighten the bolt to 10 N.m (89 lb in).

Fig 2: Locating BPMV Mounting Bracket Nuts

Courtesy of GENERAL MOTORS CORP.

Install the BPMV bracket to the strut tower.
Install the 3 nuts (2) that attach the BPMV mounting bracket to the strut tower.
Tighten:
- Tighten the nuts to 10 N.m (89 lb in).
- Reposition any lines or hoses that were moved out of place.

Fig 3: View Of Brake Pressure Modulator Valve (BPMV)

Courtesy of GENERAL MOTORS CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.