Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 981 (DATA COMMUNICATION SYSTEM)COMPONENT LOCATORDATA COMMUNICATION CONNECTORSBODY CONTROL MODULE (BCM) C3
2006 Pontiac G6 GTP, 2D Coupe, Standard
Body Control Module (BCM) C3
2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Body Control Module (BCM) C3
WARNING: This page is about a different car, the 2007 Pontiac Montana SV6, 2007 Chevrolet Uplander, and 2007 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
Connector Part Information
Connector Part Information
|
Terminal Part Information
|
Connector Terminal Identification
| Pin | Wire Color | Circuit No. | Function |
|---|---|---|---|
| 1-3 | - | - | Not Used |
| 4 | L-BU/WH | 1414 | Left Turn Signal Switch Signal |
| 5 | L-BU | 1714 | Windshield Wiper Switch Low Signal |
| 6 | L-GN | 696 | Cruise Control Cancel Signal (K34) |
| 7 | WH | 103 | Headlamp Switch Headlamps On Signal |
| 8 | BN/WH | 301 | Park Lamp Switch On Signal |
| 9 | - | - | Not Used |
| 10 | L-BU | 1872 | Headlamp Switch Headlamps Off Signal |
| 11 | - | - | Not Used |
| 12 | PU | 524 | Headlamp Dimmer Switch High Beam Signal |
| 13 | PK | 94 | Windshield Washer Switch Signal |
| 14 | BN | 1356 | Flash To Pass Switch Signal |
| 15 | BK/WH | 1251 | Ground |
| 16 | TN | 2144 | Hazard Switch Signal |
| 17 | D-BU/WH | 1415 | Right Turn Signal Switch Signal |
| 18 | L-GN | 1715 | Windshield Wiper Switch High Signal |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.