Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 972 (LIGHTING SYSTEMS)REPAIR INSTRUCTIONSLICENSE LAMP BULB REPLACEMENT
2006 Pontiac G6 GTP, 2D Coupe, Standard
License Lamp Bulb Replacement
2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION License Lamp Bulb Replacement
WARNING: This page is about a different car, the 2007 Pontiac Montana SV6, 2007 Chevrolet Uplander, and 2007 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
License Lamp Bulb Replacement
| Callout | Component Name |
|---|---|
| Preliminary Procedure: Remove the rear license plate lamps. Refer to Rear License Lamp Replacement . |
|
| 1 | License Plate Lamp Bulbs (Qty: 2) Tip: Pull the bulbs straight from the lamp sockets. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.