SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2006G6 GTP, 2D COUPE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 972 (LIGHTING SYSTEMS)REPAIR INSTRUCTIONSDAYTIME RUNNING LAMP REPLACEMENT
2006 Pontiac G6 GTP, 2D Coupe, Standard

Daytime Running Lamp Replacement

2006 Pontiac G6 GTP, 2D Coupe, StandardSECTION Daytime Running Lamp Replacement
WARNING: This page is about a different car, the 2007 Pontiac Montana SV6, 2007 Chevrolet Uplander, and 2007 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Daytime Running Lamp
GM1795987Courtesy of GENERAL MOTORS CORP.
Daytime Running Lamp Replacement

Callout Component Name

Preliminary Procedures

  1. Remove either the LF or RF headlamp in order to access the daytime running lamp nuts. Refer to Headlamp Assembly or Headlamp Bulb and/or Cornering, Sidemarker, Park, Turn Signal Bulb Replacement .
  2. Disconnect the bulb socket from the lamp by rotating the socket a quarter turn counterclockwise.
1 Park Turn Daytime Running Lamp Nuts (Qty: 3)
NOTE: Refer to Fastener Notice .

Tighten:  Tighten the nuts to 6 N.m (53 lb in)
2 Park Turn Daytime Running Lamp Assembly
Tip:  Push the lamp assembly out through the front of the bumper fascia.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.